GE Profile DPVH880 Manual Del Propietario E Instalación página 38

Installation Instructions
REVERSING THE DOOR SWING (if desired)
[] REVERSE DOOR HANDLE
AND CAPS (CONT.)
E Reassemble the inner handle to the outer handle,
using 3 screws (#8 x 0.625" tapping screws).
/
Inner
handle
F Assemble the new right-side door cap
{from reversibility kit), using 2 screws
(#8 x 0.625" tapping screws}.
Do0rcap
Put the chrome cover aside on a soft, protected
flat surface.
[] REVERSE HINGE AND CAPS
• Lag the inner door down on a soft, protected
flat surface so that the inner part faces up.
• Remove the 2 black plug buttons on the opposite
side of the hinge, using a putty knife or thin-blade
screwdriver.
• Disassemble the inner door cap from the inner
door by removing 2 screws {#8 x 0.75" tapping
screws).
• Disassemble the hinge from the inner door
by removing/4 screws {#8-32 x 0.50" machine
screws).
Inner door
>2xD
• Assemble the hinge to the opposite side
of the inner door, using/4 screws {#8-32 x 0.50"
machine screws).
• Assemble the new inner door cap {from
reversibility kit) on the opposite side of the hinge,
using 2 screws {#8 x 0.75" tapping screws).
• Install the 2 black plug buttons on the opposite
side of the hinge in the 2 remaining holes.
Replace
2xD
screws
d0orcap
38