Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Instructions
[]
LEVEL THE WASHER OR DRYER
[]
Stand the washer or druer upright.
Move it
close to its final location.
[]
Make sure that the washer or druer is level
bu placing a level on top. Check side to side
and front to back.
[]
Use an open
ended wrench
to adjust the
legs in and out.
Tighten the lock
nut against
the bottom
of the pedestal.
....
NOTE: To minimize
vibration,
the locking
nuts
must be tight.
[]
REMOVE
SHIPPING
SCREWS
Removethe 4 shipping screws on the back side
of the washer.
[]
FINALIZE THE INSTALLATION
Refer to the washer or druer Installation Instructions
to complete the installation.
[]
REINSTALL THE DRAWER
[]
Check to
be sure the
slides are
closed.
[]
Slide the
drawer
into the
Drawer
opening.
Align the
drawer
supports
to the
slides on each
side.
[]
Reinstall the original screws into each drawer
slide. Tighten both screws.
[]
Open the drawer fullu. Slide drawer divider
into slots in the center of the drawer. The
drawer should slide smoothlu
when Uou push
it closed.
45
Publicidad
