Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Instructions
EXHAUSTING THE DRYER (cont.)
USING FLEXIBLE METAL DUCT
FOR TRANSITION
VENTING
Rigid or semi-rigid
metal ducting is
recommended
for use as transition
ducting
between the drger and the wall. In special
installations
when it is impossible to make a
connection
with the above recommendations,
then
a UL-listed flexible metal transition
duct mag be
used between the drger and wall connection
onlg.
The use of this ducting will affect drg time. Onlg
those foil-tgpe
flexible ducts, if ang, specificallg
identified for use with the appliance
bg the
manufacturer
should be used. In the United States,
the duct must complg with the Outline for Clothes
Drger Transition
Duct, Subject 2158A.
If flexible metal transition
duct is necessarg,
the following
directions
must be followed:
• Use the shortest length possible.
• Stretch the duct to its maximum
length.
• Do not crush or collapse.
• Never use flexible metal ducting inside the wall
or inside the drgen
• Avoid resting the duct on sharp objects.
• Venting must conform
to local building codes.
FOR TRANSITION
VENTING
(DRYER TO WALL), DO:
• DO cut duct
as short as
possible and
install straight
into wall.
• DO use elbows
when turns are
necessarg.
Elbows
DO NOT:
IR
)
• DO NOT bend or
collapse ducting.
Use elbows if
turns are
necessarg.
• DO NOT use
excessive
exhaust length.
Cut duct as short
as possible.
• DO NOT crush
duet against
the wall.
• DO NOT set
drger on duct.
24
Publicidad
