Publicidad
Idiomas disponibles
Idiomas disponibles
Before you call for service...
Troubleshooting Tips
Save time and money! Review the charts on the following pages,
or grit ge.com. You may not need to call for service.
PROBLEM
Possible Causes
What To Do
Dryer shakes or
Someshaking/noise is normal.
• Hove drger to an even floor space, or adjust leveling legs
makes noise
Drger mag be sitting unevenlg
as necessarg until even.
Clothes take too long
Improper or obstructed ducting
• Check the Installation Instructions to make sure the
to dry
drger venting is correct.
• Make sure ducting is clean, free of kinks and
unobstructed.
• Check to see if outside wall damper operates easilg.
Improper sorting
* Separate heavg items from lightweight items (generallg,
a well-sorted washer load is a well-sorted drger load}.
Large loads of heavg fabrics
• Large,heavg fabrics contain more moisture and take
(like beach towels)
longer to drg. Separate large, heavg fabrics into smaller
loads to speed drging time.
Controls improperlg set
• Hatch control settings to the load gou are drging.
Lint filter is full
• Clean lint filter before everg load.
Blown fuses or tripped circuit
• Replacefuses or reset circuit breakers. Sincemost
breaker
drgers use 2 fuses/breakers, make sure both are
operating.
Overloading/combining loads
• Do not put more than one washer load in the drger at
a time.
Underloading
• If gou are drging onlg one or two items, add a few items
to ensure proper tumbling.
The DRYdryness level
Load consistsof a mixture
• When combining heavg and light fabrics in a load,
was chosenbut load is
of heavg and light fabrics
choose MOREDRY.
still damp
Exhaust sgstem is blocked
• Inspect and clean exhaust sgstem.
Control pads not
Controls accidentallg put in
• PressSTART/PAUSE.
responding
service mode
Controlsaccidentallg put in
• Hold the LOCKbutton for 3 seconds to unlock the drgen
lock mode
Controls performed an
• Resetthe in-house breaker.
incorrect operation
Dryer doesn't start
Control panel is "asleep"
• This is normal. PressPOWERto activate the control panel.
Drger is unplugged
• Hake sure the drger plug is pushed completelg into
the outlet.
Fuse is blown/circuit breaker
• Check the building's fuse/circuit breaker box and
is tripped
replace fuse or reset breakenNOTE:Electric drgers
usetwo fuses or breakers.
Drger was accidentallg paused
• If the light on the START/PAUSE button is flashing,
when starting Delag Start
the drger is paused. PressSTART/PAUSEto restart
the countdown.
No numbers displayed
during cyde, only lights
46
Drger is continuouslg
monitoring
the amount
of
moisture
in the clothes
• This is normal. When the drger sensesa low level of
moisture in the load, the drger will displag the drg time
remaining.
Publicidad
