Parkside PMFS 200 C3 Traduccion Del Manual De Instrucciones Originale página 6

MULTI SANDER PMFS 200 C3
Introduction
Congratulations on the purchase of your
new appliance. You have chosen a high-
quality product. The operating instructions
are part of this product. They contain important infor-
mation about safety, usage and disposal. Before
using the product, please familiarise yourself with all
of the operating and safety instructions. Use the
product only as described and for the range of appli-
cations specified. Please also pass these operating
instructions on to any future owner.
Intended use
Depending on the sandpaper being used, this
appliance is suitable for the dry sanding of wood,
plastic, metal, filler and also painted surfaces. The
appliance is particularly suitable for corners, edges
and hard-to-reach areas. Any other usage of or
modification to the appliance is deemed to be
improper and carries a significant risk of accidents.
The manufacturer accepts no responsibility for
damage(s) resulting from improper usage. This
appliance is not intended for commercial use.
Features
ON/OFF switch
Adapter fitting
Reducer for external extraction appliances
Mains cable
Dust bag
Dust box
Release button for dust box
Clamping levers
Orbital sander plate
Clamping rails
Delta sander plate
Screws (4x)
Random orbital sander plate
Speed selector
│ GB │ IE
■ 2
Rubber pin (4x)
Hex key
u Sanding sheet alignment tool
Package contents
1 Multi Sander
1 Random orbital sander plate with Velcro fastener
1 Orbital sander plate with Velcro fastener
1 Delta sander plate with Velcro fastener
2 Random orbital sanding sheets
(grain size 80/240)
2 Orbital sanding sheets (grain size 80/240)
2 Delta sanding sheets (grain size 80/240)
1 Dust box
1 Reducer for external extraction appliances
4 Rubber pins (pre-installed)
4 Screws (pre-installed)
1 Hex key
1 Sanding sheet alignment tool
1 Set of operating instructions
Technical specifications
Rated power consumption 200 W
Nominal voltage
Rated idle speed
Rated oscillation speed
Protection class
Noise and vibration data
Noise measurement value determined in accord-
ance with EN 62841. The A-rated noise level of
the power tool is typically as follows:
Sound pressure level
Sound power level
Uncertainty
Wear ear muffs!
Rated acceleration, typically
Hand/arm vibration
Uncertainty
230 V ∼, 50 Hz
n 7000–12000 min -1
0
14000–24000 min -1
II / (double
insulation)
L = 74.3 dB (A)
PA
L = 85.3 dB (A)
WA
K = 3 dB
a = 5.428 m/s 2
h
K = 1.5 m/s 2
PMFS 200 C3