Publicidad
Idiomas disponibles
Idiomas disponibles
4. Set-up and Assembly
Installing the Armrest
1. Switch on the unit and lower the backrest using the remote control.
2. Plug the wiring harness connector and the air line into the side of the steel frame and into the corresponding
connectors of the armrest (Figure 1).
3. Lift the armrest with the air line and cable plugged in and hang the hooks on both sides of the steel frame
(Figure 2).
4. Insert the rollers at the rear end of the armrest into the attachment (Figure 3) and move the armrest backwards
and downwards. Then push the armrest backwards and finally fasten it with two M5 screws (Figure 4).
66
Publicidad
