Descargar Imprimir esta página

Hoover WindTunnel MAX Multi-Cyclonic Manual Del Propietário página 14

Publicidad

Idiomas disponibles

Idiomas disponibles

BELT
A, CAUTION A
To reduce the risk of personal injury from moving
parts, unplug vacuum
before servicing.
The belt is located
under
the bottom
plate of the
vacuum
and should
be checked
from time to time
to be sure it is in good condition.
When To Replace
Replace
belt
if it is stretched,
cut
or
broken.
To check the belt, refer to Fig. 4.24 - 4.26.
How To Replace
4.24 Turn vacuum over so bottom side is facing up.
Rotate
red upper latch (A) counter
clockwise.
4.25 Slide 2 lower latches (B) to the unlock position.
4.26 Lift off bottom
plate.
4.27 Remove
used belt from brushroll (C) then from
motor shaft (metal rod) (D) and discard.
4.28 With lettering
on outside
of belt, slide new belt
over motor shaft (metal rod) (E).
Then slip other end of belt around
area of brushroll
without bristles (F).
With belt in place, pull and slide brushroll
into nozzle
making
sure that the brushroll
end caps are in the
correct orientation.
4.29 Reposition
bottom
plate, aligning
(2) screws
on nozzle
with lower latches
(4.25,B).
Press firmly
on all front edges (4.29)
of nozzle guard
to ensure
that it is properly
seated.
Slide (2) lower latches
to
lock
in
position,
and
rotate
red
upper
latch
clockwise.
• IMPORTANT-
Rotate
brushroll
manually
to make
sure belt is
not twisted.
Actual
model
may vary from images
shown.
14

Publicidad

loading