Descargar Imprimir esta página

Hoover WindTunnel MAX Multi-Cyclonic Manual Del Propietário página 12

Publicidad

Idiomas disponibles

Idiomas disponibles

Carbon Filter • How to Clean
(Available
on select
models
only).
Your Carbon
Filter is located
on the underside
of
the Filter made with
HEPA media.
• IMPORTANT- I
DO NOT RINSE
OR WASH
the Carbon
Filter.
Cyclonic Filter Assembly:How to Clean
,A CAUTION ,A
To reduce
the risk of personal
injury - unplug
vacuum
before
servicing.
Do not use vacuum
without
dirt cup or filters in place.
Remove
dirt cup as described
in Fig. 4.3.
4.9
Twist
filter
assembly
(A) counter-clockwise.
Remove
assembly
from dirt cup.
4.10 Dirt and debris
can be cleaned
from the filter
assembly
with the Dusting/Upholstery
Tool.
4.11 If further cleaning
of the internal filter assembly
is required,
turn dust skirt (B) counterclockwise
to
remove.
4.12 Grab dirt cup shroud (C), pull straight
off and
clean with dusting/upholstery
tool.
After cleaning,
replace
dirt cup shroud (C) onto and
inside edge of filter assembly
and align center lines
with Hoover _ emblem.
Place skirt (B) onto
shroud,
align (4) slots with (4) tabs, and turn clockwise to lock.
Place the filter assembly
(4.9, A) on the dirt cup,
aligning (3) tabs on filter with (3) slots on dirt cup (B)
and twist it clockwise
to secure into position.
BRUSHROLL: How to Clean
,A CAUTION A
To reduce the risk of personal injury from moving
parts, unplug vacuum before servicing.
4.13 Turn vacuum over so bottom side is facing up.
Rotate
red upper latch (A) counterclockwise.
4.14 Slide (2) lower latches (B) to the unlock position.
4.15 Pivot out bottom
plate and remove any debris
and/or hair from brushroll.
_lilkl
4.16 Reposition
bottom
plate, aligning
(2) screws
on
nozzle
with
lower
latches
(4.14,B).
Press
firmly on all front edges
(4.16)
of nozzle
guard
to
ensure
that it is properly
seated.
Slide
(2) lower
latches
to lock
in position,
and rotate
red upper
latch clockwise.
The Hoover _ emblem
and center
lines on the dirt
cup should
all align on the front of the dirt cup if
assembled
correctly.
Replace
dirt cup as described
in Fig. 4.5.
Actual
model
may vary from images
shown.
12

Publicidad

loading