RC4WD Miller Motorsports Z-E0135 Manual página 15

Features
• Water-proof and dust-proof for all-weather races;
in water; Clean and dry it soon after the use for avoiding the connectors get rusty.)
• External programming port, easy to connect to the Program Card when setting the ESC;
• Proportional brake with 4 steps of maximum brake force adjustment and 8 steps of drag brake force
adjustment;
• 9 steps of acceleration(punch) adjustment from "soft" to "Very aggressive" to fit for different kinds of models,
tires and tracks;
• Multiple protections: Low voltage cut-off protection / Over-heat protection / Throttle signal loss protection /
Motor lock-up protection;
• One-button(the "SET" button on the ESC) to set the ESC, and easy to reset all parameters to the factory
default settings;
• Compatible with the optional device-the portable Digital LED Program Card, especially convenient for outdoor
use.
How to Set Parameters
• We suggest users using tweezers or needle-nose pliers to set parameters by plugging / unplugging the jumper cap (as shown in the picture above); For example,
if you want set the battery type to the "LiPo" mode, you only need to plug the jumper cap into left two pins of the battery pin header.
Programmable Items
1. Running Mode: 3 Options (Fwd / Br / Rev, Fwd / Br, Fwd / Rev). The "Fwd / Br / Rev" is the default option.
• "Fwd / Br / Rev" Mode:
The vehicle can go forward, backward and brake. This mode uses "Double-click" method to make the vehicle reverse. When moving the throttle Trigger/Stick
from the neutral Reverse Position for the 1st time, the ESC begins to brake the motor and the motor slows down but is still running, so the reverse is NOT
performed immediately. When the throttle Trigger/Stick is moved to the Reverse Position again, if the motor speed slows down to zero (i.e. stopped), the
vehicle will move in reverse. This "Double-click" method prevents reversing immediately when the brake function is frequently used in steering. Therefore, this
mode is often used in daily practice.
• "Fwd / Br" Mode:
The vehicle can go forward and brake, but no reversing, so this mode is often used in competitions.
• "Fwd / Rev" Mode:
Uses "Single-click" method to make the vehicle reverse. When moving the throttle Trigger/Stick from neutral zone to backward zone, the vehicle reverses
immediately, so this mode is usually used for rock crawlers.
2. Battery Type: 2 Options (Lipo, NiMH), the "Lipo" is the default option.
(We strongly suggest you set the "Cell Count" manually instead of using the "Auto-identification" mode.)
Programmable Items
1. Running Mode
Note 1
2. Drag Brake Force
3. Low Voltage Cutoff
4. Start Mode (Punch)
5. Max. Brake Force
6. Max. Reverse Force
7. Initial Brake Force
8. Throttle Range
9. Timing
Note 1: Fwd=Forward, Rev=Reverse, Brk=Brake
Note 2: When set to the "Auto-identification" mode, the battery pack can only be identified as 2S, 4S and 6S Lipo. Because the normal voltage of each LiPo
cell varies from 2.6V to 4.2V, it's not easy to correctly calculate the cell count of a discharged LiPo battery pack. Therefore, we strongly suggest you set the
"LiPo Cells" manually.
Reset All Items to Default Values
At any time when the throttle is located in neutral zone (except in the throttle calibration or parameters program process), press and hold the "SET" key for over 3
seconds, the red LED and green LED will flash simultaneously , which means each programmable item has be reset to its default value. The ESC needs to be
restarted to complete the reset process.
(Note: please uninstall the cooling fan before using this ESC
Parameter List of Z-E0135: (Italics in the form below indicate factory defaults)
Option 1
Option 2 Option 3
Fwd/Br Fwd/Rev/Br Fwd/Rev
0% 5% 10%
Disable 2.6V/Cell 2.8V/Cell
Level 1 Level 2 Level 3
25% 50% 75%
25% 50% 75%
drag brake
0% 20%
force
6% 9%
12%(Wide)
(Narrow) (Normal)
0.00 deg 3.75 deg 7.50 deg
(Fwd=Forward, Br=Brake, Rev=Reverse)
Option 4 Option 5 Option 6
80%
20% 40% 60%
3.0V/Cell 3.2V/Cell 3.4V/Cell
Level 4 Level 5 Level 6
100% Desactivar
100%
40%
11.25 deg 15.00 deg 18.75 deg
14
Option 7 Option 8 Option 9
100%
Level 7 Level 8 Level 9
22.50 deg 26.25 deg
RC4WD Miller Motorsports
1/10 Pro Rock Racer RTR