Sony RM-TP503 Manual De Instrucciones página 25

4
Select the type of component connected (Ex: VCR).
To display other items, use the JOG DIAL or touch 4
or $ to scroll through the list.
The FUNCTION&USER IR:MAKER CODE screen
appears.
5
Touch the remote controller mode of the connected
component (Ex: Sony VTR1).
The component selected in steps 4 to 5 will be
registered at the function selected in step 3, and the
SETUP screen reappears. A long beep sound is emitted
to indicate that registration was successful. Operation
is now possible from the FUNCTION screen.
If a series of short beeps is emitted, redo the
registration procedure. If this occurs, make sure the
receiver/amplifier is turned on and that the
commander is pointing toward the receiver/amplifier
during operation.
To stop registration at any time
Touch EXIT during step 2 or touch CANCEL during steps 3 to 5.
Notes
• All icons may not be displayed when registering components
made by certain manufacturers.
• Some commands may not function even though they are
displayed when registering components made by certain
manufacturers.
FUNCTION screen setup
You can set the FUNCTION screen not to display
components you do not use.
1
Touch SETUP.
The SETUP screen appears.
2
Touch FUNCTION HOOK UP.
The FUNCTION HOOK UP screen appears.
3
Select the function not to be displayed and touch
NO.
To display other items, use the JOG DIAL or touch 4
or $ to scroll through the list.
The selected component is set not to appear and the
SETUP screen reappears.
To display the components set not to be displayed
Touch YES instead of NO in step 3.
z
Components that have been registered (see page 24) are set
to "YES" automatically.
Note
When a function does not appear in the display even though
FUNCTION HOOK UP is set to YES, turn the JOG DIAL to
display the function.
Downloading receiver/amplifier data
Various types of data can be downloaded from the
receiver/amplifier.
When carrying out this operation, make sure that the receiver/
amplifier's power is on, and be sure to point the commander's
transmitter/receiver section toward the display on the receiver/
amplifier. Also, operate the commander at a distance of about
1~2 meters from the receiver/amplifier.
1
Touch SETUP.
The SETUP screen appears.
GB
25