Turning The Power On And Off; Switching Audio Modes - Eclipse CD7000 Manual Del Propietário

Turning the power on and off

When the power is turned on, the state used
when the power was turned off such as CD and
tuner playback is restored.
When the vehicle has no ACC position on the
ignition switch, care is needed when turning off
the main unit. Follow Step 2 or Step 3 when
turning off the power.
When power is OFF, press the
1
[SOURCE/PWR] button.
The power will come ON.
ATTENTION
When the main unit's power is turned on for
the first time or if the battery terminals have
been disconnected because of a reason
such as vehicle maintenance and the power
is then turned back on, the main unit will
start up in FM1 mode. After this, the
broadcast stations will be searched for
automatically and stored in buttons [1] to
[6].
When power is ON, press the
2
[SOURCE/PWR] button until you
hear a beep (for more than two
second).
The power will go OFF and the main
unit will be in Standby.
If you press the [SOURCE/PWR]
button again for more than two
seconds, the power will go completely
off.
When power is ON, press the
3
[SOURCE/PWR] button until the
[ACC OFF] is displayed.
The power will go completely OFF.
Names of controls and parts
ATTENTION
If a car is not equipped with an ACC position,
press the [SOURCE/PWR] button until the
[ACC OFF] is displayed.

Switching Audio Modes

Press the [SOURCE] button for
1
less than one second.
Press the button to switch mode in the
following sequence:
*1
TUNER o SIRIUS o CD (MP3/WMA)
*1 *2
CDC o MS o AUX (AUX1/AUX2) o
*1
iPod o TUNER o ˜ ˜ ˜ ˜
*1: Cannot be selected if the corresponding
device is not connected to the main unit.
*2: Not displayed if no disc is inserted
III
*2
o
17