Regulatory Compliance and Safety Information Cisco Catalyst 9400 Series Switches
Statement 1071 Warning Definition
Warning
IMPORTANT SAFETY INSTRUCTIONS
Before you work on any equipment, be aware of the hazards involved with electrical circuitry
and be familiar with standard practices for preventing accidents. Read the installation instructions
before using, installing, or connecting the system to the power source. Use the statement number
at the beginning of each warning statement to locate its translation in the translated safety
warnings for this device.
SAVE THESE INSTRUCTIONS
Statement 191 Voluntary Control Council for
Interference (VCCI) Class A Warning for Japan
Warning
This is a Class A product based on the standard of the VCCI Council. If this equipment is used in
a domestic environment, radio interference may occur, in which case, you may be required to
take corrective actions.
Statement 256 Class A Warning for Hungary
Warning
This equipment is a class A product and should be used and installed properly according to the
Hungarian EMC Class A requirements (MSZEN55022). Class A equipment is designed for typical
commercial establishments for which special conditions of installation and protection distance
are used.
Statement 294 Class A Warning for Korea
Warning
This is a Class A device and is registered for electromagnetic compatibility (EMC) requirements
for industrial use. The seller or buyer should be aware of this. If this type was sold or purchased
by mistake, it should be replaced with a residential-use type.
Regulatory Compliance and Safety Information - Cisco Catalyst 9400 Series Switches
3