cecotec Conga 2290 Absolute Manual De Instrucciones página 23

ENGLISH
- Power adapter. Fig. 5
- Mixed tank. Fig. 6
Primary and high-efficiency filters. Fig. 7
-
Jaliscazo brush. Fig. 8
-
- Side brushes (4). Fig. 9
- Mops (2). Fig. 10
Autoclean brush. Fig. 11
-
Remote control Fig. 12
-
1. Mode and time display
2. Clock settings
3. Automatic charge/Back home
4. Start/Pause button
5. Direction buttons
6. Spiral cleaning
7. Room cleaning
8. Scrubbing levels
9. Scheduling
10. Edge cleaning
11. Power levels
2. BEFORE USE
- This robot vacuum cleaner includes a package designed to protect it during transport.
Take the robot vacuum cleaner out of the box. Keep the original box and other elements
in a safe place, as this will help you prevent product damage when transporting it in the
future. In case the original packaging is disposed of, make sure all packaging materials
are recycled accordingly.
- Make sure all parts and components are included and in good conditions. If there is any
piece missing or in bad conditions, contact the Technical Support Service of Cecotec
immediately.
Warnings
Remove all objects around the robot vacuum cleaner such as clothing, papers, cables,
-
curtains or other fragile objects which may block or slow down the operation of the robot
vacuum cleaner. Fig. 13
- If the room to be cleaned is near a balcony or stairs, a physical barrier must be placed in
order to prevent product damage and ensure safe operation. Fig. 14
Direct exposure to sunlight or great light contrasts may affect the correct operation of
-
the sensors. If this happens, the robot will stop operating, move it to a new location for it
to start operating again.
44
3. INSTALLATION
- Place the charging base against the wall and leave a minimum free space of 2 metres to
the front and 1 metre to each side. Fig. 15
Connect the charging base to a power socket. Wind and store the remaining cable in the
-
lower part of the charging base to prevent accidents. Fig. 16
- Install both side brushes in their corresponding slots, located on the robot lower part.
Press until they click to make sure they are properly fixed. Fig. 17
Press the power switch located on the side of the robot. Make sure the power switch is in
-
the on position (I). Fig. 18
- Place the robot on the charging base and make sure the charging terminals on the robot
match those of the charging base. Once the robot is properly placed, it will beep once and
the light indicator will light up. If the light is oscillating orange, it means the battery is
not completely charged. To ensure the maximum cleaning time, wait until the light turns
into steady blue, as this will indicate the battery is fully charged and the robot is ready to
clean. Fig. 19
4. OPERATION
Starting the cleaning. Fig. 20
- Hold down the Start/Pause button on the robot to turn it on.
- Press the Start/Pause button on the robot vacuum cleaner, on the remote control or on
the app to start cleaning.
Note
- If the robot runs out of battery while cleaning, it will automatically return to the charging
base. Once the battery is fully charged, the robot can start a new cleaning cycle.
- If there is no good access to the charging base, the robot will not be able to return to it. If
this happens, place it manually on the charging base.
Pausing the cleaning. Fig. 20
Press the Start/Pause button on the robot vacuum cleaner, on the remote control or on
-
the app to pause the cleaning process.
- Press the Start/Pause button on the robot vacuum cleaner, on the remote control or on
the app to resume the cleaning process.
Returning to the charging base
Press the Back home button on the robot, on the remote control or on the app (with a house
icon) in order to send the robot to the charging base. The robot vacuum cleaner will continue
vacuuming until it reaches the charging base.
ENGLISH
45