SCHOLTES TIS 632CPD L Manual De Instrucciones página 33

To exit this mode, follow the procedure described above.
The display will show the text DE and OF and the hob will
be switched off. When it is next switched on, the hob will
function normally.
The EXTENSO TECHNOLOGY mode
The EXTENSO TECHNOLOGY
the power of two "interconnected" hotplates to the
same level. It can be activated if the two hotplates are
OFF, by pressing the EXTENSO TECHNOLOGY
button
The EXTENSO TECHNOLOGY
while the hob is on by pressing the
TECHNOLOGY button once; the LEDs corresponding
to both linked hotplates light up.
The 2 LEDs remain lit as long as the hotplates are
linked (if EXTENSO TECHNOLOGY
pressed again, the hotplates are disconnected and
are both set to power level 0).
Pressing the +, - or Max buttons for one of the two
Flexi hotplates also affects the display corresponding
to the other hotplate.
To deactivate the EXTENSO TECHNOLOGY
the button .
A timer may be set for the
TECHNOLOGY; this appears on the display and both
LEDs corresponding to the linked hotplates light up.
When the Timer button is pressed, the two linked
hotplates are treated as if they were a single zone.
Selecting and using EXTENSO TECHNOLOGY
To begin using the EXTENSO
the button. To set the power level (see above).
EXTENSO TECHNOLOGY
Once you have selected EXTENSO TECHNOLOGY
by pressing the button , the 2 LEDs corresponding
to the EXTENSO TECHNOLOGY
light up; it will then be possible to control both as if
they were a single zone. The power level will appear
on both displays. If only the upper or lower part is in
use, the display corresponding to the unused zone
will begin to flash, and after 3 minutes cooking will
automatically revert to standard mode
TECHNOLOGY).
! Once activated, the EXTENSO TECHNOLOGY
also be programmed, using the same procedure as
described for the individual hotplates.
can be used to set
can be activated
EXTENSO
button is
, press
EXTENSO
TECHNOLOGY, press
operation
for both hotplates
(notEXTENSO
can
! Accessories
For optimal EXTENSO TECHNOLOGY
we recommend the use of pans with an elliptical or
elongated base and a major diameter of at least 250
mm; if using pans with a smaller diameter, we
recommend positioning them in the upper or lower
part as indicated by the X symbol.
If the saucepan is not in the centre of the screen
printing detail, you may hear a whistling sound or a
slight buzzing noise; this does not indicate a hob
malfunction. We recommend adjusting the position
of the pan so that it is in the centre of the EXTENSO
TECHNOLOGY zone
GB
performance,
33