Installation Requirements; Tools And Parts; Options - Whirlpool WHP1000SQ Manual De Uso Y Cuidado

Tools and Parts

Gather the required tools and parts before starting installation.
The parts supplied are in the washer drum.
Parts needed (not provided with washer):
Inlet hoses
To order:
Call the dealer from whom you purchased your washer.
Reference the toll-free number on the front page of the Use
and Care Guide.
Visit the website on the front page of the Use and Care Guide.
NOTE: Replace inlet hoses after 5 years of use to reduce the risk
of hose failure. Record hose installation or replacement dates for
future reference.
Parts supplied:
A
B
A. Drain hose form
B. Transport bolt hole plug (4)
C. Beaded strap
Tools needed for installation:
Open end wrenches
17 mm and 13 mm
Level
Wood block
Alternate Parts
Your installation may require additional parts. If you are interested
in purchasing one of the items listed here, call the toll-free
number on the cover or in the "Assistance or Service" section.
If You Have You Will Need to Buy
Laundry tub or Sump pump system (if not already
standpipe taller available)
than 96" (2.4 m)
Overhead sewer Standard 20 gal. (76 L), 30" (76.2 cm) tall
drain tub or utility sink and sump pump
(available from local plumbing suppliers)
Floor drain Siphon break, Part Number 285834;
additional drain hose
Part Number 8318155; and connector kit,
Part Number 285835
Drain hose too 4 ft (1.2 m) drain hose extension kit,
short Part Number 285863
Water faucets 2 longer water fill hoses:
beyond reach of fill 6 ft (1.8 m) Part Number 76314,
hoses 10 ft (3.0 m) Part Number 350008
4

INSTALLATION REQUIREMENTS

Flat washers
C
Ruler or measuring tape
Pliers (that open to
1⁹⁄₁₆" [39.5 mm])
Flashlight (optional)
Pedestal
You have the option of purchasing pedestals of different heights
separately for this washer. You may select a 10" (25.4 cm) or a
15.5" (39.4 cm) pedestal. These pedestals will add to the total
height of the washer for a total height of approximately
48" (121.9 cm) or 53.5" (135.9 cm).
A
A. 10" (25.4 cm) pedestal
B. 15.5" (39.4 cm) pedestal
To order, call the dealer from whom you purchased your washer
or refer to the "Assistance or Service" section of this manual.
Pedestal
Color
Height
10" (25.4 cm) White
15.5" (39.4 cm) White
Stack Kit
Are you planning to stack your washer and dryer? To do so you
will need to purchase a Stack Kit.
To order, call the dealer from whom you purchased your dryer or
refer to the "Assistance or Service" section of this manual. Ask
for Part Number 8541503.

Options

B
Part Number
WHP1000SQ
WHP1500SQ