Washer Disposal; Installation Requirements; Tools And Parts - Whirlpool 3LCHW9100YQ Instrucciones De Instalación

Model Nomenclature
3L – Voltage 230v/50Hz plug code
CHW – Commercial Horizontal Washer
91 – Model Type number

Tools and Parts

Gather the required tools and parts before starting
installation.The parts supplied are in the washer drum.
Tools needed for connecting the water inlet hoses:
Pliers (that open to 39.5 mm [1
■
Flashlight (optional)
■
Tools needed for installation
Open-end wrenches 1/2" and 9/16"
■
Torx T-20 Security screwdriver
®†
■
1/4" nut driver
■
Level
■
Wood block
■
Ruler or measuring tape
■
Parts supplied
A
D E
A. U-shaped hose form
B. Water inlet hoses (2)
C. Inlet hose washers (4)
†® TORX is a registered trademark of Saturn Fasteners, Inc.
4

WASHER DISPOSAL

INSTALLATION REQUIREMENTS

⁄ "])
9
16
B
C
F
G
D. Transit bolt hole plug (4)
E. Beaded tie strap
F. Drain hose
G. Hose clamp
Alternate Parts
Your installation may require additional parts. If you are interested
in purchasing one of the items listed here, contact your
authorized Whirlpool distributor.
If You Have You Will Need to Buy
Laundry tub or Sump pump system (if not already available)
standpipe taller
than 2.4 m (96")
Overhead sewer Standard 76 L (20 gal. ), 762 mm (30") tall
drain tub or utility sink and sump pump
(available from local plumbing suppliers)
Floor drain Siphon break, Part Number 285320;
additional drain hose, Part Number 8318155;
and Floor drain kit, Part Number 280129
Drain hose 1.2 m (4 ft.) drain hose extension kit,
too short Part Number 285834