Washer Disposal; Installation Requirements; Tools And Parts - Whirlpool 3LCHW9100WQ Instrucciones De Instalación

Tools and Parts

Gather the required tools and parts before starting installation.
The parts supplied are in the washer drum.
Tools needed for connecting the water inlet hoses
■ Pliers (that open to
39.5 mm [1 / "])
9
16
Tools needed for installation
■ Open end wrenches
1/2" and 9/16"
■ Torx ®† T-20 Security
screwdriver
■ 1/4" nut driver
Parts supplied
A B
E
A. U-shaped hose form
B. Water inlet hoses (2)
C. Inlet hose washers (4)
D. Transit bolt hole plug (4)
E. Beaded tie strap
†® TORX is a registered trademark of Acument Intellectual Properties, LLC.
4

WASHER DISPOSAL

INSTALLATION REQUIREMENTS

■ Flashlight (optional)
■ Level
■
Wood block
■ Ruler or measuring tape
D
C
Alternate Parts
Your installation may require additional parts. If you are interested
in purchasing one of the items listed here, contact your
authorized Whirlpool distributor.
If You Have You Will Need to Buy
Laundry tub or Sump pump system (if not already
standpipe taller available)
than 2.4 m (96")
Overhead sewer Standard 76 L (20 gal. ), 762 mm (30") tall
drain tub or utility sink and sump pump
(available from local plumbing suppliers)
Floor drain Siphon break, Part Number 285320;
additional drain hose,
Part Number 8318155; and Floor drain
kit, Part Number 280129
Drain hose 1.2 m (4 ft.) drain hose extension kit,
too short Part Number 285834