Zipper Maschinen ZI-HS16E Instrucciones De Servicio página 38

14.2.2 Uncoupling the PTO shaft
There is a motor contact device inside the self-locking sleeve. When the sleeve is
removed, the motor cannot start. So the machine only works when it is connected to
motor only or to PTO only.
To uncouple the PTO shaft proceed as follows:
1. Reduce tractor throttle to IDLE before disengaging PTO. Apply the parking brake and turn off the
engine.
2. Pull up the locking pins and slide the lower draft arms of the tractor off from the splitter hookup
pins.
3. Pull up the hitch pin and slide the upper draft arm off from the mounting bracket.
4. Release the spring pins located on both ends of the driveshaft. Slide the PTO driveshaft off from the
PTO shaft ends on the gearbox and tractor respectively.
5. Mount the plastic self-locking sleeve.
15 TRANSPORT
15.1 ZI-HS16E
For easier transport, the log splitter has two wheels, a support wheel and a transport handle.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-HS16E / ZI-HS22EZ / ZI-HS30Z / ZI-HS30EZ
N O T I C E
WARNING
 When using a crane for lifting, attach the crane hook
only to the intended lifting point (a) - see illustration on
the left.
 Never attach the crane hook to the transport handle
(b)!
 Before moving the log splitter, make sure that the
cover on the oil tank is firmly closed!

To move the splitter, grasp the handle (b) and carefully
tilt machine backwards!
A. Moving support wheel to the transport position: To
mount the support wheel, remove the spring bolt and
push the square tube with the support wheel into the
holder (1). Then select the appropriate hole and fix the
square tube in the desired position using the spring
bolt (2).
TRANSPORT
38