Publicidad
Idiomas disponibles
Idiomas disponibles
Unpair the base and the headset
To unpair the base and the headset:
Press the pairing button located on the base and hold for at least
5 seconds. The base indicator light flashes blue and red.
Then press the same pairing button twice briefly. The indicator
light on the base will turn purple for 2 seconds.
,
On the headset
hold down the
until you hear a beep.
The headset indicator light will flash blue and red as well.
Adjusting the volume
Place the headset over your ears
48
and
buttons for 5 seconds
Use the - and + buttons to adjust the volume. Set the volume of
your sound source to a medium level to improve the quality of the
transmission.
A signal sounds when you have reached the maximum or
minimum level.
To protect your hearing, never set the volume to the maximum.
The wireless headset is primarily intended
for people with hearing loss and can
provide an extremely high sound level.
Prolonged listening to this headset at too
high a volume level may result in hearing
loss.
To avoid hearing loss, do not use the
headset at high volume for too long
and set the volume to a level that is not
harmful. The higher the volume, the more
your hearing is at risk.
Remote operation
• Some sound sources automatically switch off the speakers
when the headset socket is active. In this case, you can listen
to your sound source exclusively through your headset.
• On other sources, such as televisions, you can listen to sound
through both your headset and the television speakers. This
allows another person to enjoy the programme being viewed.
• If you wish to mute your television speakers, press the MUTE
button on the remote control or activate the mute function in
the configuration menus of your device. Refer to your television
set's operating instructions for more information.
49
Publicidad
