Motorola Solutions PMPN4633 Manual De Usuario página 16

MN009418A01-AC
Chapter 5: Charging Procedure
Figure 3: Battery Charging
Procedure:
1. Place the Multi-Unit Charger (MUC) on a flat surface.
2. Firmly insert the power supply into the charger DC Inlet Socket at the back of the charger.
3. Plug the power supply power cord into a matching power outlet.
Upon successful power-up, each pocket LED shows green for one second and displays IMPRES 2
CHARGER. If the LEDs do not flash and no message is displayed, check power cord connections.
4. Insert the radio with battery or stand-alone battery into an available pocket.
The followings are the indication when the radio or stand-alone battery is properly seated in the
pocket:
● Charging status of a radio is indicated by the LED status indicator or display of the radio.
● The display of the MUC shows the charging status of Pocket 1 only.
The radio or stand-alone battery is ready for use when the LED is steady green.
NOTE:
To ensure optimized charging performance, turn off the radio while charging unless the radio is
transmitting data wirelessly on Wi-Fi or Bluetooth.
Grip the radio body when inserting, or removing the radio from the charger. Avoid pulling the
radio antenna when removing the radio.
5.1
Display Messages and LED Indications
This section provides information on IMPRES 2 display messages and LED indications.
16