Motorola Solutions PMPN4633 Manual De Usuario página 22

MN009418A01-AC
Chapter 5: Charging Procedure
Status
● The charger pocket is a spe‐
cial type.
Standby
● Battery is waiting to rapid
charge.
● Battery may be too hot, too
cold, or low voltage.
● Charger may be too hot
Preparing a Lithium-ion Battery for Shipment-IMPRES 2 Battery, must Discharge
Table 11: Preparing a Lithium-ion Battery for Shipment-IMPRES 2 Battery, must Discharge
Status
Charger Powers On
Battery Detected
Battery Discharging
Ship Lithium Complete
Fault
● Battery may not be making
proper electrical contact with
the charger.
● Battery is not an IMPRES 2
battery.
● An unknown condition is pre‐
venting the battery from be‐
ing discharged.
● Charging was completed be‐
fore the Ship Lithium goal
could be reached.
22
Charger Display
WARNING: HOT BAT-
TERY WAITING TO
CHRGE or COLD BAT-
TERY WAITING TO
CHRGE or VERY LOW
BATTERY WAITING TO
CHRGE or HOT CHARG-
ER WAITING TO
CHRGE
Charger Display
IMPRES 2 CHARGER
IMPRES 2 BATTERY
SHIP LI CHARGE xxx% Rat-
ed Cap
LI READY TO SHIP xxx%
Rated Cap
WARNING: NOT
CHARGEABLE REMOVE&
REINSERT or WRONG
BATT TYPE CANNOT
SHIP LI or CANNOT
DISCHARGE FOR LI
SHIPMENT or SHIP
INCOMPLETE Low Ca-
pacity:yy% or RADIO
POCKET CANNOT SHIP
LI or CHARGING
POCKET CANNOT SHIP
LI
LED Indicator
Blinking Amber
LED Indicator
Green for approximately one
second
Steady Amber
Steady Amber
Steady Green
Blinking Red