Motorola Solutions PMPN4003 Guia Del Usuario página 10

MN010173A01-AA
Chapter 2: Charger Operations
Chapter 2
Charger Operations
This section contains the charging information of your charger.
2.1
Charging the Batteries
Prerequisites: Use only Motorola Solutions authorized batteries. Charge the batteries at room temperature.
Use only the assigned charger when charging the supported batteries.
Procedure:
1. Place the multi-unit charger horizontally on a flat surface.
NOTE: If you have more than one multi-unit charger, it is recommended to place the multi-unit
charger in a vertical position mounted to the mounting bracket.
2. Insert the power supply adapter to the female connector of the multi-unit charger.
3. Plug the power supply adapter to the power outlet.
If powering up the multi-unit charger is successful, the LED shows green for one second.
If powering up the multi-unit charger is unsuccessful, check the power cord connection.
4. Align and insert the batteries (2X) with battery tray into the charger pocket.
5. Make sure that the battery is in contact with the charger contact.
If the battery is inserted correctly and the battery is being charged in the rapid charge mode, the LED
indicator shows solid red.
6. To remove the battery trays from the charger pocket, pull the battery trays from the charger pocket.
10