Before use
What's in the box
Check to be sure the box includes all the supplied accessories shown
below. Please contact the store where you purchased this product if
any of these accessories are missing or have been damaged during
transportation.
Power cord × 1
HDMI cable × 1
Batteries
for remote control (AA) × 2
Owner's manual
(this document) × 1
Note about pinpoint feet
High-precision metal pinpoint feet are attached firmly to the bottom
plate of this unit.
The stands for these feet are loose, but when the unit is placed in
position, it is supported by these pinpoint feet, which will effectively
disperse vibrations.
Chassis
Foot-stand (metal)
o Apply the included felt pads to the bottoms of the foot-stands to
avoid scratching the surface where the units are placed.
8 8
DC power connection cords
× 2
Remote control
(RC-1156) × 1
Felt pads × 8
Warranty card × 1
Pinpoint foot (metal)
Screws that attach foot-stand
Precautions for use
o These units are very heavy, so take care to avoid injury during
installation.
o Do not install these units in locations that could become hot. This
includes places that are exposed to direct sunlight or near a radia-
tor, heater, stove or other heating equipment. Moreover, do not
place them on top of an amplifier or other equipment that gener-
ates heat. Doing so could cause discoloration or deformation.
o Avoid locations that are extremely cold or exposed to excessive
humidity or dust.
o In order to enable good heat dissipation, leave at least 20 cm (8")
between these units and walls and other equipment when install-
ing them.
If you put them in a rack, take precautions to prevent overheating
by leaving at least 5 cm (2") open above the tops of the units and
at least 10 cm (4") open behind them.
o If installing in a rack with a glass door, do not use the remote con-
trol OPEN/CLOSE button to open the disc tray when the door is
closed. If the disc tray is forcibly prevented from moving, damage
could result.
o Place each unit in a stable location near the audio system that you
will use with it.
o DO NOT place anything, not even CDs, CD-Rs, LP records or cas-
sette tapes, on top of the units. Doing so could cause damage.
o Do not put cloth on top of the units or place them on top of bed-
ding or thick carpet. Doing so could cause them to overheat or
damage them.
o Do not lift or move the unit during playback because the disc
rotates at high speed. Doing so could damage the disc.
o Always remove any loaded disc before moving this unit or pack-
ing it for installation in a different location, for example. Moving
the unit with a disc inside could cause damage.
o Supply voltage to the power unit that matches the voltage indi-
cated on the rear panel. If you are in any doubt regarding this
matter, consult an electrician.
o Do not open the bodies of the units as this might result in dam-
age to the circuitry or cause electric shock. If a foreign object
should get into one of the units, contact your dealer.
o When removing the power plug from an outlet, always pull
directly on the plug. Never pull on the cord itself.
o If a TV is turned on while the unit is on, static might appear on the
TV screen depending on the characteristics of the TV broadcast
signal. This is not a malfunction of the unit nor of the TV. If this
occurs, turn the unit off.