Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
DO NOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.
Young children and the infirm. This appliance is not
•
intended for use by young children or infirm persons
without supervision.
•
This product is not intended for use by persons (including
children) suffering from diminished physical, sensory or
mental abilities; lack of experience, knowledge or skills
unless they are supervised by a person responsible for their
safety. Children should never be left alone with this product.
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of serious personal
injury, turn unit off before making any adjustments
or removing/installing attachments or accessories.
An accidental start-up can cause injury.
Battery Installation (Fig. B)
WARNING: Batteries can explode, or leak, and can cause
injury or fire. To reduce this risk:
1. Using a 2 mm hex wrench (not supplied), remove the two
screws
9
holding the battery cover.
2. Remove the battery cover
8
3. Insert two fresh AAA batteries
compartment
11
making sure to match (+) and (-)
terminals correctly and reinstall the battery cover.
4. Fit the battery cover
8
over the battery compartment
Install and tighten the two screws
using a 2 mm hex wrench.
5. Ensure that the battery cover
-
Carefully follow all instructions and warnings on the
battery label and package.
-
Always insert batteries correctly with regard to polarity
(+ and -), marked on the battery and the equipment.
-
Do not short battery terminals.
Do not charge batteries.
-
-
Do not mix old and fresh batteries. Replace all of them
at the same time with new batteries of the same brand
and type.
Remove dead batteries immediately and dispose of per
-
local codes.
Do not dispose of batteries in fire.
-
-
Keep batteries out of reach of children.
-
Remove batteries if the device will not be used for
several months.
-
Transporting batteries can possibly cause fires if the
battery terminals inadvertently come in contact with
conductive materials such as keys, coins, hand tools
and the like. So when transporting individual batteries,
make sure that the battery terminals are protected and
well insulated from materials that could contact them
and cause a short circuit.
18
as shown in Fig. B.
10
into the battery
11
.
9
of the battery cover
8
8
is tightly secured.
Low Voltage Indicator
If the battery strength is low, the LCD
symbol and power down.
1. Replace batteries.
OPERATION
Instructions for Use
WARNING: Always observe the safety instructions and
applicable regulations.
WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect battery pack
before making any adjustments or removing/
installing attachments or accessories. An accidental
start-up can cause injury.
Power On (Fig. C)
1. To turn the wrench on, press set button
2. The LCD
6
will display the current value.
Auto Power Off
1. The wrench will power off automatically after thirty seconds
of not being used.
Manual Power Off
1. Turn the wrench on if it is not powered on.
2. Press and hold the button
7
until the LCD
Battery Level Gauge
Battery gauge indicates four levels of remaining charge.
1.
indicates ~ 75% to 100% remaining
2.
indicates ~ 50% to 75% remaining
3.
indicates ~ 25% to 50% remaining
4.
indicates 25% or less remaining
5. When there is not enough energy remaining in the battery
to operate reliably, the battery frame will blink and the
wrench will turn off.
Setting Required Torque (Fig. A, D)
1. Pull and hold down on the torque adjustment collar
2. Twist the anti-slip handle
4
displayed on the LCD
.
6
NOTE: If you see a LO or HI instead of a value, you have
reached the minimum or maximum torque setting.
3. Release the torque adjustment collar
desired torque value.
4. Use the LCD
6
to confirm the torque value is set correctly.
Blinking Torque Value
The torque value will blink if the current torque value is off by
at least two percent of the set torque value.
6
will display a battery
.
7
6
displays "OFF".
5
.
until the desired torque value is
to lock in the
5
Publicidad
