Nuova Simonelli OSCAR II Instrucciones De Manejo página 27

Never block the intake and/or heat dissipation
grills, in particular those for the cup warmer.
The user must never replace the unit's power
supply cord. If this cord is damaged, turn off the
unit and have it replaced by a professionally
qualified technician.
Should it be necessary to replace the power
cord, this replacement operation must only be
performed by an authorized service centre or by
the manufacturer.
3. USE
To facilitate aeration of the unit, position the
aeration portion of the machine 15 cm from
walls or other machinery.
Be extremely careful when using the steam
nozzle.
Never place your hands under the nozzle and
never touch it right after use.
Remember that to install, maintain, unload and
regulate the unit, the qualified operator must
always wear work gloves and safety shoes.
When adding the coffee, the operator must
never put his hands into the container.
The noise level of the machine is less than
70db.
For machines connected to the mains water
supply, the minimum pressure must be 2 bar
and the maximum pressure for correct machine
operation must not exceed 4 bar.
The coffee machine must not be left switched
on without supervision, i. e. without the pres-
ence of an operator.
Simonelli Group is not responsible for any dam-
age caused by malfunction of the machine, in
case this machine is left on without the pres-
ence of the operator.
4. DISPOSAL
Should you decide to stop using this type of
unit, we suggest you render it inoperable by
unplugging it and cutting the power supply cord.
Never dispose of the machine in the environ-
ment: to dispose of the machine, contact an
authorized center or contact the manufacturer
for pertinent indications.
The machine points out that the product at the
end of its life cycle must be collected separate-
ly from the other wastes.
The user for this reason will have to give the
equipment that got to its life cycle to the suitable
separate waste collection centres of electronic
and electro-technical wastes, or to give it back to
the seller or dealer when buying a new equip-
ment of equivalent type, in terms of one to one.
The suitable separate waste collection for the
following sending of the disused equipment to
recycling, the dealing or handling and compati-
ble environment disposal contributes to avoid
possible negative effects on the environment
and on the people's health and helps the recy-
cling of the materials the machine is composed
of. The user's illegal disposal of the product
implies the application of administrative fines as
stated in Law Decree n.22/1997" (article 50 and
followings of the Law Decree n.22/1997).
5. SHIPPING AND HANDLING
MACHINE ID
When communicating with the manufacturer
Simonelli Group, always cite the machine ID
number.
The machine is transported on pallets containing
several machines inside cartons strapped to the
pallet.
Operators performing any shipping or handling
operations must wear gloves, safety shoes and
overalls with elasticized cuffs.
Always move pallets using adequate equipment
(i.e. fork lift trucks).
Slowly lift the pallet approximately 30 cm off
the ground and drive to the loading zone. After
having made certain that there are no obstacles,
things or persons in the way, proceed with load-
ing.
Once the destination has been reached, again
using adequate lifting equipment (i.e. fork lift
truck) and after having made certain that there
is nothing and no one in the unloading area, set
the pallet on the ground and move it to the
storage area; always carry the load at a height
of approximately 30 cm from the ground.
Before performing the following operations,
make certain that the load is in stable and will
not fall when the straps are cut.
Wearing gloves and safety shoes, the operator
must cut the straps and store the product.
During this operation, see the product technical
features for the weight of the machine being
stored and proceed as necessary.
Once the machine has been released from the
pallet or container, do not pollute the environ-
ment with these items.
27