Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION OF SAFETY SUPPORT
(required for Canadian installation ONLY)
A safety support cable is provided to help prevent the ceiling fan from
falling, please install it as follows.
Step 1 . Slip the spring washer, then the flat washer onto the wood screw,
then drive the wood screw into the side of the brace that holds the outlet box.
Leave 3mm (1/8") of space between the support brace and the flat washer.
(Fig.11)
Step 2 . lnsert the safety cable through the mounting bracket and one of the
holes in the outlet box into the ceiling. Adjust the length of the safety cable to
reach the wood screw and flat washer by pulling the extra cable through the cable
clamp until the overall length is correct, put the end of the cable back through
the cable clamp, forming a loop at the end of the cable. Tighten the cable clamp
securely. Now, put the loop in the end of the safety cable over the wood screw
and under the flat washer. Tighten the wood screw securely. (Fig.12)
NOTE: Although the safety support cable is required for Canadian
installations only, it is a good idea to make the attachment with any
installation.
10 | KICHLER.COM
Support Brace
Ceiling
Outlet Box
Fig. 11
Safety Cable
Cable Clamp
Wood Screw
Fig. 12
Flat Washer
Spring Washer
Wood Screw
Publicidad
