OPERATING INSTRUCTIONS (continued)
INSTALLING THE TRANSMITTER BATTERIES
WARNING: Chemical Burn Hazard. Keep batteries away from
children.
This product contains a lithium button/coin cell battery.
If a new or used lithium button/coin cell battery is swallowed or enters the
body, it can cause severe internal burns and can lead to death in as little
as 2 hours.
Always completely secure the battery compartment. If the battery
compartment does not close securely, stop using the product, remove the
batteries, and keep it away from children. If you think batteries might have
been swallowed or placed inside any part of the body, seek immediate
medical attention.
a) The cells shall be disposed of properly, including keeping them away
from children;
b) Even used cells may cause injury.
Step 1. Remove the safety screw and the battery cover from the back of the
transmitter. Retain safety screw. (Fig. 30)
Step 2. Install two 3V CR2032 batteries (included) with the + side facing up.
(Fig. 31)
Step 3. Reinstall the the battery cover and the safety screw to the back of the
transmitter.
NOTE: If not used for long periods of time (several months), remove batteries
to prevent damage to the handset control. Store the control awayfrom
excessive heat or humidity.
20 | KICHLER.COM
Battery Cover
Safety Screw
Fig. 30
Fig. 31
Battery Cover
Fig. 32
Safety Screw