Publicidad
Idiomas disponibles
Idiomas disponibles
ELECTRICAL CONNECTIONS
CAUTION: To avoid possible electrical shock, be sure you have turned o
the power at the main circuit panel.
Step 1 . Insert the receiver into the ceilling mounting bracket with the
flat side of the receiver facing the ceiling (Fig.13) for best performance,
make sure the black antenna wire (on the end of the receiver) remains
extended, and does not become tangled with the electrical wires.
WARNING: To avoid possible electrical shock, be sure you have turned o
the power at the main circuit panel before wiring. Follow the steps below
to connect the fan to your household wiring. Use the wire connectors
supplied with your fan. Secure the connectors with electrical tape.
Make sure there are no loose wire strands or connections
WARNING: This control is designed for use with "DC Motor Ceiling Fans"
ONLY. DO NOT use with any other type of electrical appliance.
WARNING: All wiring must conform to national and local electrical codes.
lf you feel you do not have enough electrical knowledge, have a licensed
electrician install the control.
WARNING: lf your house wires are di erent colors other than referenced
in this manual, stop immediately. A professional electrician is recommended
to determine proper wiring.
Make each of the wire connections illustrated in Fig. 13. Secure each with the
wire nuts provided.
WARNING: Check to see that all connections are tight, including ground, and
that no bare wire is visible at the wire connections.
Fig. 13
54" Fit | 11
Publicidad
