Publicidad
Idiomas disponibles
Idiomas disponibles
HANGING THE FAN (continued)
Step 4. Carefully feed fan wires and safety cable up through the downrod.
Thread the downrod into the motor coupling until the hitch pin holes are
aligned. Next, replace the hitch pin and retaining clip.
NOTE: Be careful not to jam the hitch pin against the wiring inside of
the downrod. Tighten both set screws. (Fig. 8)
Step 5. Slip the coupling cover, canopy trim ring (smooth finished side
facing motor body), and canopy onto the downrod. Carefully reinstall
the hanger ball onto the downrod. Carefully reinstall the cross pin
through the hanger ball and downrod.
NOTE: Be careful not to jam the cross pin against the wiring inside
of the downrod. Make sure the cross pin is in the correct position.
Tighten the cross pin. Tighten the set screw on the hanger ball.
Make sure the wires are not twisted. (Fig. 9)
Step 6. Lift the motor body into position and place the hanger ball into
the mounting bracket. Rotate the entire assembly until the "Check Tab"
has dropped into the "Registration Slot" and seats firmly. (Fig.10) The
entire motor body should not rotate if this is done correctly.
WARNING: Failure to reattach the cross pin and seat the "Check Tab" can
cause the fan to fall from the ceiling during operation. Take special care to
make sure this pin is reattached.
Fig. 8
Hitch Pin
Downrod
Hitch Pin
Retaining Clip
Motor Coupling
Set Screw
Fig. 9
Cross Pin
Hanger Ball
Canopy
Canopy
Trim Ring
Coupling Cover
Motor Body
Fig. 10
Mounting Bracket
Registration Slot
Hanger Ball
Retaining Clip
Set Screw
Set Screw
Hanger Ball
Check Tab
54" Fit | 9
Publicidad
