Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLING THE SWITCH COVER (CONTINUED)
Step 2. Place the key hole slots in the switch cover over the 2 mounting
plate screws that were loosened on the mounting plate. Rotate the switch
cover (clockwise) until it locks in place against the mounting plate screws
at the narrow ends of the key hole slots.
Align the remaining hole in the switch cover with the remaining hole in the
mounting plate. Install the mounting plate screw that was removed from
the mounting plate into the aligned holes. Tighten all 3 mounting plate
screws to secure the switch cover in place. (Fig.19)
INSTALLING THE SWITCH HOUSING
CAUTION: Before continuing installation, confirm that the power is still
turned o at the main circuit breaker or by removing the circuit fuse.
Turning the power o using a wall switch is not su cient to prevent
electrical shock.
Step 1. Remove the three preinstalled mounting screws from the outside
edge of the switch cover. Retain mounting screws. (Fig. 20)
14
KICHLER.COM
Mounting Plate
Switch Cover
Mounting Plate Screw
Switch Cover
Mounting Screws
Fig. 19
Fig. 20
Publicidad
