Publicidad
Idiomas disponibles
Idiomas disponibles
HANGING THE FAN
CAUTION: To avoid possible electrical shock, be sure
you have turned o the power at the main circuit panel.
REMEMBER to turn o the power before you begin
installation. This is necessary for your safety .
To properly install your ceiling fan, follow the steps below.
Step 1. Before attaching fan to outlet box (not included), ensure the
outlet box is securely fastened to at least two points to a structural
ceiling member (a loose box will cause the fan to wobble). Pass the
120 volt supply wires from the ceiling outlet box through the center
of the ceiling mounting bracket. Install mounting bracket to outlet
box in ceiling using the screws and washers included with the outlet
box. (Fig. 5)
Step 2. Remove the retaining clip and hitch pin from the downrod
assembly. Remove the hanger ball from the downrod assembly by
loosening the set screw on the hanger ball (do not remove),
unscrewing and removing the cross pin, and unscrewing the hanger
ball (counterclockwise) from the downrod. (Fig. 6)
NOTE: Make sure to keep removed hardware separate to avoid
confusion during installation.
Step 3. Loosen the two set screws (do not remove) on the motor
coupling. (Fig. 7)
8
KICHLER.COM
Outlet Box
Ceiling Mounting Bracket
Flat Washer (included with outlet box)
Screw (included with outlet box)
Hanger Ball
Set Screw
Cross Pin
Hitch Pin
Retaining Clip
Downrod
Motor Coupling
Set Screw
Set Screw
Fig. 5
Fig. 6
Set Screw
Fig. 7
Publicidad
