Nolan X Serie Seguridad E Instrucciones página 24

X-804
1.4 Insert one side of the PINLOCK
it in position (Fig.8).
1.5 Widen the visor and fasten the other side of the PINLOCK
pin (Fig.9).
1.6 Release the visor.
1.7 Remove the protective film from the PINLOCK
entire silicone profile of the inner visor adheres to the visor.
1.8 Assemble the visor on the helmet (see instructions above).
2 CHECKING AND ADJUSTING THE STRETCH
Check that the PINLOCK
closing the visor and ensuring that they do not move with respect to each other.
Should the PINLOCK
gradually and not excessively, both external adjustment levers turning them upwards,
to increase the stretch (Fig.7). The maximum stretch is achieved when the pin adjust-
ment external levers are placed outwards.
WARNING
- Dust between the two visors may cause both surfaces to scratch.
- Scratched PINLOCK
should therefore be replaced.
- Regularly check the correct stretch of the PINLOCK
moving and scratching both surfaces.
- If, in use, the helmet visor fogs up and/or condensation forms between the visors,
check that the PINLOCK
- An excessive and early stretch of the PINLOCK
sive adherence against the visor surface and/or permanent deformations with
subsequent inability to properly perform future adjustments.
- Intense sweating/breathing, use in particular weather conditions (low tempera-
tures, and/or high humidity and/or sudden changes in temperature and/or heavy
rain) and/or intense and prolonged use may affect the performance of the PIN-
LOCK inner visor, causing fogging or condensation formation. In such cases, to
®
restore the system efficiency after using the helmet, remove the PINLOCK
visor from the helmet visor and leave it to dry in warm and dry air. The same pro-
cedure should be applied to the helmet, which should be left to dry to remove any
humidity that may have formed as a result of the conditions described above.
3 DISASSEMBLY
3.1 Disassemble the visor equipped with the PINLOCK
above).
3.2 Widen the visor and release the PINLOCK
3.3 Release the visor.
4 MAINTENANCE AND CLEANING
- Disassemble the PINLOCK
cloth, gently clean it with mild liquid soap. Remove all soap under running water.
- Leave the visor to dry in warm and dry air without wiping it.
22
INSTRUCTIONS FOR USE
inner visor onto one of the two visor pins and hold
®
inner visor has been correctly assembled by opening and
®
inner visor not be tightly fixed to the visor, simultaneously move,
®
visors and inner visors may cause reduced visibility and
®
inner visor is both properly assembled and stretched.
®
inner visor from the visor. Using a damp and soft
®
inner visor to the other
®
inner visor and check that the
®
inner visor to prevent it from
®
inner visor may result in exces-
®
inner visor (see instructions
®
inner visor from the pins (Fig.9).
®
inner
®