Nolan X Serie Seguridad E Instrucciones página 26

X-804
REMOVABLE INNER COMFORT PADDING
The removable comfort padding consists of:
- liner
- side cheek pads (right and left)
- strap covering
All components can be completely removed and washed.
The cheek pads are also characterised by removable inner expanding foam padding.
To remove and/or fit the comfort padding, open the visor completely (see instructions
above).
1 DISASSEMBLING THE CHEEK PADS
1.1 Open the chin strap (see specific instructions).
1.2 Pull the front of the padding of the left cheek pad towards the inside of the helmet
to release the front snap fastener placed on its rear part (Fig. 15).
1.3 Grasp the front of the padding of the left cheek pad and turn it upwards to release
the upper snap fastener placed on the back (Fig.16).
1.4 Pull the rear of the padding of the left cheek pad towards the inside of the helmet
to release the rear snap fastener placed on its rear part (Fig.17).
1.5 Pull the tail of the cheek pad comfort padding towards the inside of the helmet
to release the rear tab from its seat in the rear trim; then pull the cheek padding
completely out of the helmet (Fig.18).
1.6 Follow the same steps on the right side of the helmet.
WARNING
- Check that the red front button A on the back of the padding of both cheek pads
has remained correctly engaged in the NERS slide B as illustrated in Fig.19. If, on
the other hand, it has remained attached to the polystyrene cheek pad, detach it
from the latter and reposition it properly by fastening to its red seat C on the back
of the padding.
- Do not remove the polystyrene cheek pads from the helmet shell.
2 DISASSEMBLING THE INNER EXPANDING FOAM PADDING OF THE CHEEK PADS
To facilitate the washing of the inner comfort padding components, the cheek pads of
the helmet are equipped with inner expanding foam padding that can be removed from
the fabric lining. To remove the padding, proceed as follows after disassembling the
cheek pads from the helmet (see instructions above).
2.1 Slightly remove the inner expanded foam padding from the fabric lining of the left
cheek pad (Fig.20).
2.2 Follow these operations with the right cheek pad padding.
WARNING
- Once the inner expanded foam paddings have been removed from the cheek
pads, make sure that the red front snap button "A", the upper snap button "D",
the rear snap button "E" and the NERS safety slide "B" are correctly fastened to
the rear frame of the fabric lining of the cheek pads (Fig. 19); if not, reposition them
appropriately.
24
INSTRUCTIONS FOR USE