Nolan X Serie Seguridad E Instrucciones página 33

The shape of the upper part reduces the aerodynamic resistance of the helmet and
improves its stability at high speed in a forward-leaning riding position, especially as a
continuation of the race hump on the rider's race suit. In contrast, the shape of the side
parts improves the stability of the helmet at high speeds when riding above the fairing.
The RAS is attached to the helmet by means of a rear screw and elastic plates, and can
therefore be removed from the helmet depending on the conditions of use and/or riding
situations, e.g. in the presence of a passenger.
1 DISASSEMBLY
1.1 Release the elastic screw cover cap from the RAS. (Fig.47).
1.2 Unscrew the screw using the Torx T10 wrench.
1.3 Turn the RAS towards the rear of the helmet and pull its lower hooks off the lower
side supports attached to the shell (Fig.48).
1.4 Screw the rear screw back into place.
WARNING
- The two lower side supports attached to the shell cannot and must not be re-
moved from the shell.
2 ASSEMBLY
2.1 Unscrew the rear screw using the Torx T10 wrench.
2.2 Insert the lower hooks of the RAS into the slots in the lower side supports Fig.48).
2.3 Rotate the RAS upwards until the upper teeth engage in the seats on the support
attached to the shell (Fig.49).
2.4 Screw the rear screw back into its seat and attach the elastic cover cap to the RAS
(Fig. 47)
Check that the RAS is correctly fastened into all its seats by pulling it slightly
backwards.
WARNING
- The RAS has been designed for use on the racetrack only. In the event of mechan-
ical stress, accidental bumps or falls, it may detach from the helmet and become
damaged.
- When using, transporting, cleaning, maintaining or handling the helmet, be careful
not to damage the RAS and duly follow the assembly and disassembly instruc-
tions provided.
- To clean the RAS, use lukewarm water and mild soap only. Leave to dry at room
temperature away from direct sunlight and/or heat sources.
- When carrying a passenger, we recommend disassembling the RAS from the hel-
met to ensure it does not bother or pose a danger to the passenger.
- The two lower side supports and the upper support affixed to the shell cannot and
should not be removed from the shell.
- If the RAS does not fasten correctly to the helmet or is damaged, disassemble it
from the helmet and speak to a Nolangroup authorized dealer.
INSTRUCTIONS FOR USE
X-804
31