Publicidad
Idiomas disponibles
Idiomas disponibles
X-804
8
ASSEMBLING THE CHEEK PADS
WARNING
Take the padding of the left cheek pad and make sure that the red front snap but-
ton "A", the upper "D" snap button, the rear snap button "E" and the NERS safety
slide "B" are correctly fastened to the rear frame of the fabric lining of the cheek
pad (Fig. 19). Furthermore, check that the NERS slide "B" is positioned upwards,
in the fastening position, with its end protruding from the contour of the cheek
pad. Otherwise, reposition them appropriately.
8.1 Insert the rear tab of the left cheek pad comfort padding into the seat in the rear
trim (Fig.18).
8.2 Insert the chin strap into the cavity in the cheek pad and press near the rear snap
button located at its rear to fasten it to the corresponding housing on the polysty-
rene cheek pad (Fig.17).
8.3 Press the padding of the left cheek pad against the polystyrene cheek pad and si-
multaneously turn it inwards to engage the upper hook on the back of the padding
to its seat on the polystyrene cheek pad (Fig.16).
8.4 Press at the front snap fastener to fasten to the relevant seat on the polystyrene
cheek pad (Fig.15).
8.6 Check whether the fasteners and hooks are correctly fastened by slightly pulling
the pad of the cheek pad towards the inside of the helmet and checking whether
it remains adherent to the polystyrene cheek pad.
8.7 Follow these operations with the right cheek pad padding.
WARNING
-
If your helmet is equipped with the D-Ring retention system, close it as described
in the attached D-Ring instruction label.
-
Remove the inner comfort padding only when cleaning or washing is required.
-
Never use the helmet if all parts of the inner comfort padding have not been prop-
erly and correctly reassembled.
-
Carefully wash by hand and use only mild soap and water at 30° C max.
-
Rinse using cold water and dry at room temperature, away from direct sunlight.
-
Never machine-wash the inner comfort padding.
-
The inner polystyrene is an easily deformable material. It is intended to change or
get partially destroyed to help absorb shocks.
-
Do not modify or alter the internal polystyrene components in any way.
-
Clean the inner polystyrene components using a damp cloth only and allow them
to dry at room temperature away from direct sunlight.
-
Never use tools or equipment to carry out the operations described above.
LINER AJUSTABLE FITTING ( LAF )
The different anatomical conformation of motorcyclists' heads sometimes requires an
adaptation of the comfort padding of the liner to the head itself. The liner padding of the
helmet can be adjusted thanks to the LINER ADJUSTABLE FITTING (LAF) system. This
allows the helmet fit to be changed with respect to the standard one, adapting it to the
user's head shape and needs. In this regard, the fabric covering liner has four different
areas of removable expanded foam padding, respectively upper, rear and right and left
sides. The standard thickness of these pads (8 mm) can be increased or decreased
26
INSTRUCTIONS FOR USE
Publicidad
