Publicidad
Idiomas disponibles
Idiomas disponibles
2610054085.qxp_Layout 1 5/28/19 7:21 AM Page 18
Step 2
To remove: pull the accessory off the back-
ing pad. Hold the accessory by the "loop"
backing material and peel away from back-
ing pad (as shown in figure 4), rather than
grabbing the sponge/microfiber material.
To attach the bristle brush: first remove
the backing pad completely and then at-
tach brush by aligning the threads of the
output shank and finger tighten the bristle
brush in a counterclockwise direction.
Step 3
cessories in a dry and temperate environment to avoid deterioration.
jury and property damage.
The Dremel Versa is designed to work with
spray, foam, gel, or liquid cleaners. Before
using cleaning solutions please read and
follow manufacturer's warnings and in-
structions for use. Cover the surrounding
area that you are cleaning to protect from
spray. Use splash guard on open surfaces
to contain spray. Recommended to apply
water and cleaning agent to the surface
that needs cleaning and/or to the acces-
sory directly. If applying water or cleaning
18
Using Versa for Cleaning
Use only Dremel® Versa accessories. Other accessories are not designed
for this tool and may lead to personal injury or property damage. Store ac-
Always comply with the application, disposal and warning instructions of
the cleaning solution manufacturer. Improper use can result in personal in-
Assembly
Fig 4
agent directly on accessory, shake excess
liquid off or "pulse" the tool by quickly
turning it "on" and then "off" in a con-
tained areas (i.e. bucket or sink) to reduce
spray.
To start cleaning, press and release the
On/Off button (Fig. 1) while the accessory
is in contact with the surface to be
cleaned. The tool will come up to speed
quickly. Gently press to the surface to be
cleaned, do not press too hard, let the tool
Publicidad
