Publicidad
Idiomas disponibles
Idiomas disponibles
2610054085.qxp_Layout 1 5/28/19 7:21 AM Page 19
Step 3
do the work. Move the tool in a circular
pattern. Do not hold the tool in one spot
for more than 5 seconds.
To turn the tool off, press and release the
on/off button.
▶ Electronic Monitoring
Your tool is equipped with an internal elec-
tronic monitoring system that helps to
maximize motor and battery performance
by limiting the current to the tool when
overload and stall conditions occur.
If you stall the tool for too long the tool will
automatically turn off. Once this happens,
simply press and release the on/off button
twice to start the tool again, and continue
using it.
When the battery becomes close to empty,
the tool may shut down more frequently
than normal. If this happens, it is time to
recharge the tool.
▶ Accessories
The kit includes a backing pad, splash
guard, and 4 different accessories.
Spot-test a small section of the surface
that you intend to clean for acceptability
before cleaning entire job.
▼ SPLASH GUARD
It is recommended to use the splash guard
for all wet cleaning applications. Keep
splash guard in the "extended" position
Using Versa for Cleaning
VERSA
Extended Position
while tool is running to contain the spray
of water and cleaning solutions.
To get into tighter spaces, the splash
guard can be retracted into the "up" posi-
tion.
To remove the splash guard entirely, turn
the tool off, unscrew the backing pad,
then twist the splash guard a quarter turn
to remove. Screw the backing pad back
on.
▼ WHITE FOAM ERASER PAD – PC362
Multipurpose pad recommended for use
VERSA
Retracted Position
19
Publicidad
