Publicidad
Idiomas disponibles
Idiomas disponibles
11. Receiver Code Learning - Programming the
Operating Frequency of the Receiver
11.1
The receiver must be programmed within 2 minutes of
restoring electricity to the fan. Program the receiver code
by pushing and holding down the remote control OFF
button for 5-10 seconds. The ceiling fan lights will blink
when the receiver has completed programming. If no
lights are installed, push and release the "LOW" speed
button and verify if the fan spins (Figure 52).
If programming fails, shut off and turn on the electricity at
the wall switch to reset the receiver 2 minute programming
time period and repeat the above steps. If programming
continues to fail, change the remote code (see Section
10.4) and repeat this instruction as necessary until the fan
successfully completes the programming procedure.
You may need to change your location in the room when
pushing the "OFF" button to enable the receiver to catch
the programming signal.
11.2
OPERATION OF REMOTE CONTROL
IMPORTANT
Fan installation must be completed, including the
installation of the fan blades, before testing of the
remote control.
Your remote control has full control of your fan and light
NOTE: Prior to operation of the fan and light from the
(Figure 53).
remote control, set the fan speed to HIGH and turn the
light ON.
To set the desired fan speed, press the HI, MED, or LOW
button to operate your fan on high, medium or low speed.
To turn your fan off, press the OFF button.
To turn the light on, press and release the light (
button. The light will turn on at the light intensity previously
selected.
To vary the intensity of the light, hold the
(
) button down until the desired light intensity is
reached, then release the button.
All manuals and user guides at all-guides.com
Figure 52
Figure 53
)
28
REMOTE CONTROL
MED
LOW
I
H
OFF
LIGHT BUTTON
REMOTE CONTROL
COVER
MED
LOW
I
H
OFF
OFF BUTTON
LIGHT BUTTON
U.L. Model No.: CF135
Publicidad
