Publicidad
А
WAR NIN G
Electrical Shock or Personal injury Hazard.
Disconnect the electrical supply before servicing or cleaning the unit. Failure to do so
could result in electrical shock or personal injury from cleaner suddenly starting.
Review this chart to find do-it-yourself solutions for minor performance
problems. Any service needed, other than those described in these
Operating Instructions, should be performed by an authorized service
representative.
PROBLEM
POSSIBLE CAUSE
POSSIBLE SOLUTION
1. Unplugged at wall outlet.
1. Plug in firmly. Push ON-OFF
Cleaner will
switch to ON,
not run.
2. Push ON-OFF switch to ON.
2. ON-OFF switch not turned on.
3. Unplug vacuum, wait thirty (30)
minutes, plug in and switch to ON.
3. Tripped thermal protector.
4. Tripped circuit breaker/blown
fuse at household service panel.
4. Reset circuit breaker or replace
fuse.
Poor job of dirt
1. Full or clogged dust bag.
pickup.
1. Change bag.
2. Broken belt.
2. Replace belt.
3. Carpet-bare floor setting incorrect. | 3. Set in the correct position.
4. Clean hose or nozzle area.
4. Clogged hose or nozzle.
5. Hose not inserted fully.
5. Insert hose.
6. Worn agitator.
6. Replace agitator.
7. Hole in hose.
7. Replace hose.
8. Dust cover improperly installed.
8. Properly install dust cover.
9. Belt not installed on motor shaft.
9. Install belt on motor shaft.
Dust escapes
1. Bag improperly installed.
1. Properly install bag.
the paper bag.
Light will
not work.
Dirt sensor will
not work.
2. Bag torn.
2. Replace bag.
1. Burned out light bulb.
1. Replace light bulb.
1. Dirty optic cells.
1. Clean optic cells.
942
Publicidad
