Publicidad
Idiomas disponibles
Idiomas disponibles
2
INSTALLATION WORK
2.3.
INSTALLATION SPACE
In case of installing the controllers in vertical
line, keep a distance more than 50mm
between the controllers vertically.
If the distance is insufficient, the front cover
of the controller can not open wide enough.
2.4.
INSTALLATION PROCEDURES
1. Insert the edge of the screwdriver into the
groove parts at the bottom of the holding
bracket, push and turn the screw driver
and remove the controller from the holding
bracket.
2. Connection of cable.
Connect the accessory cable to the fielded
cable by soldering.
3. Attach the controller to the holding bracket and connect the cable as follows.
- In Case of Exposing Remote Control Cable
?
Fix the Holding
Bracket onto the
wall with screws
(Accessory)
Figure seen from Bottom Side
Approx. 6mm
Groove Part
Accessory Cable
(Insulate the connecting part by vinyl tape)
Load the cable
through the groove
Insert the connector
More than
50mm
Screw Driver
Field Supplied Cable
Publicidad
