Publicidad
Idiomas disponibles
Idiomas disponibles
1. GENERAL INFORMATION
1.1
INTRODUCTION TO THIS MANUAL
Please read carefully and follow the instructions detailed in this manual. Keep the manual for use and future
maintenance. Pay attention to the configuration of the DIP-switch, to the data concerning the performance (see
"Technical Data") and to the installation instructions. Improper use or incorrect operation, fitting or assembly can
damage the system as well as cause injury to people and damage to property.
2. SAFETY
This installation manual is written exclusively for competent professional personnel.
The installation, electrical connections and adjustments must be carried out conforming to good practice and
according to the regulations in force.
Incorrect installation can cause a potential hazard.
The packing materials (plastic, polystyrene, etc.) must not be allowed to pollute the environment, but must be
disposed of correctly, and must not be left within the reach of children since they can cause possible hazards.
Before starting installation, check the product is complete and undamaged.
If the power cable is damaged, it must be replaced by the manufacturer or his technical support.
Do not install the product in an explosive environment or atmosphere: the presence of flammable gas or fumes is
a serious health and safety hazard.
Before installing the drive mechanism, put in place all the structural modifications relating to safety measures and
to the protection or segregation of all the zones involving hazards of crushing, shearing, entrapment and of general
hazard.
Check that all the existing structure has the necessary requirements of strength and stability. The manufacturer of
the drive mechanism is not responsible for failing to conform to good practice in the construction of the windows to
be opened, as well as any distortion which could occur during use.
Put up the notices laid down by current regulations to identify hazardous areas.
Ensure that the electrical supply is not a temporary one, but has the required electrical boxes, and in case of doubt
or lack of (definite) information, also install:
-
suitable isolating transformers
-
thermal magnetic cut-outs suitable to voltage requirements
-
surge arrester.
Before connecting the electrical supply, ensure that the electrical rating correspond to that of electrical distribution
supply. Fit onto the supply network an allpole switch with a contact gap of at least 3 mm. Check that on the supply
side of the electrical plant there is a suitable differential residual current circuit breaker and overload protection.
When required to do so, connect to an efficient earthing/ground system fitted according to the safety regulations
in force in the country where the actuator is being installed. Before carrying out any operation (installation,
maintenance or repair), isolate the electrical supply before working on the equipment. To ensure complete isolation
from the supply current, installation is recommended of a double-pole switch of the approved type with biased-off
switch mode. The low-voltage 24 Vdc actuators must be supplied by suitable power supplies (NOT TRANSFORMERS)
of an approved Class II type (double safety insulation) having an output voltage of 24 Vdc -15% to +20% (or from 20.4
Vdc min. to 28.8 Vdc max.) When using the 24 Vdc version, the cable must have a suitable cross-section, calculated
based on the distance between the power supply and the actuator, so as not to have a voltage drop or loss.
The device is not intended to be used by people (including children) whose physical, sensory or mental capabilities
are reduced or by people who lack in experience or knowledge, unless a person responsible for their safety can
control them or give them instructions concerning the use of the device. Children must be supervised to ensure
that they do not play with the device.
The Smart chain actuator is intended only and exclusively for use for which it was designed, and the manufacturer
cannot be held responsible for damage due to its improper use. The actuator is intended exclusively for internal
installation to open top-hung and bottom-hung windows, skylights and dormer windows.
Any other use is not recommended unless with the prior approval of the manufacturer. Install the actuator according
Cross-section of cables
1,50 mm²
0,75 mm²
Max lenght of cables
~ 100 m
~ 50 m
17
Publicidad
