Publicidad
Idiomas disponibles
Idiomas disponibles
4.5
PACK AND TOOLS REQUIRED FOR ASSEMBLING THE ACTUATOR
The actuator is packed individually in a cardboard box. Each pack contains:
Electric actuator, 230VAC 50Hz with electric supply cable, support brackets, fixing bracket for top-hung window,
fixing bracket for bottom-hung window and instruction manual.
Before starting to fit the actuator, we recommend preparing the following fitting materials, tools and equipment:
Metre rule or tape measure, pencil, drill/screwdriver, set of drill bits for metal or wood, set of screw bits, electrical
pliers, screwdrivers, screws and/or threaded inserts suitable for the type of window material. AVOID using self-
tapping screws and/or three-lobed screws on any metal windows.
5. INSTALLATION
With bottom-hung windows, there is a danger of potential injury resulting from the window accidentally
falling.
It is OBLIGATORY to fit limiting arms (of the Series 1276 type), or an alternative safety system, of a suitable size
to prevent the window from accidentally falling down. In case of testing before installation, please move the chain
only when opening.
Top-hung outward opening window: Overall dimensions and fixing holes
27
Bottom-hung inward opening window: Overall dimensions and fixing holes
27
5.1
INSTALLATION SEQUENCE
-
Check that the width of the window, where the actuator is due to be fitted, is more than 320 mm. Otherwise, it is
NOT POSSIBLE to fit the actuator.
-
Check that the force required to open/close it (calculated according to the table under Point 4.2) is less than or
equal to that shown in the TECHNICAL DATA table.
-
Try manually the window opening, checking for and if necessary eliminating any sticking points that could cause
a malfunction.
-
Manually test the maximum opening of the window, checking that it is greater than the travel set by the actuator.
22
257
FILO SERRAMENTO
178
267
178
FILO SERRAMENTO
32.5
27
2.6
27
11
43
98.5
113
55
99.5
Publicidad
