Kuppersbusch FWK8850.0S Instrucciones De Uso página 63

1. Incline the wine cooler with 45 degrees, take out right lower hinge's screws with screwdriver
(Fig.1).
2. Level the wine cooler, hold the door and take out right upper hinge's screws with screwdriver, then
take out the door, put the door safety, rotate door at 180 degrees (Fig.2, Fig.3 & Fig.4).
3. Remove limited block B as per the arrows in picture, then release all the screws on limited block A,
and take away limited block A. Install the limited block A at the right side with screws, then install
limited block B, then fit the door with screws (Fig.5, Fig.6 & Fig.7).
Note: this is a two person operation
4. OPERATING INSTRUCTIONS
It is recommended that you installed your appliance in a place where the ambient temperature is
between 16-38°C (N-ST class marked on the rating plate). If the ambient temperature is above or below
recommended temperatures, the performance of the unit may be affected and it may not be possible
to obtain temperature between 5-20°C/5-10°C/10-20°C.
63