TOPDON Phoenix Max Manual Del Usuario página 30

• The battery monitoring sensor uses the battery matching function to re-match the
control module with the monitoring sensor, so as to detect the use of the battery
power more accurately, and avoid receiving wrong information from instrument
prompts which will cause false alarms.
3.5 BLEEDING (ABS Bleeding)
This function enables you to perform tests to check the operating conditions of the
Anti-lock Braking System (ABS).
It needs to be performed in the following cases:
When the ABS lines contain air.
•
• When the ABS computer, ABS pump, brake master cylinder, brake cylinder, brake line,
or brake fluid is replaced.
3.6 BRAKE (Electronic Parking Brake Reset)
This function helps you to replace and reset the brake pads.
It needs to be performed in the following cases:
• The brake pads and brake pad wear sensor are replaced.
The brake pads indicator lamp is on.
•
• The brake pads sensor circuit is short, which is recovered.
• The servo motor is replaced.
3.7 DPF (DPF Regeneration)
This function can help remove particulate matter from the trap by using combustion
oxidation methods to keep the performance of the trap stable.
It needs to be performed in the following cases:
• Replace the exhaust back pressure sensor.
Disassembly or replacement of the particle trap.
•
• Removal or replacement of fuel additive nozzles.
• Removal or replacement of catalytic oxidizer.
The DPF regeneration fault lamp is lit and matched after maintenance.
•
• Repair and replace the DPF regeneration control module.
3.8 GEAR (Tooth Learning)
This function can perform tooth learning for the car, to turn off the MIL.
It needs to be performed in the following cases:
After the engine ECU, crankshaft position sensor, or crankshaft flywheel is replaced.
•
• The DTC "tooth not learned" is present.
3.9 IMMO (Anti-theft Matching)
27