TOPDON Phoenix Max Manual Del Usuario página 32

• When the mileage is not correct due to the damaged vehicle speed sensor or the
odometer failure.
3.18 AIR BAG (Airbag Reset)
This function resets the airbag data to clear the airbag collision fault indicator, so that
the airbag computer in the vehicle can run normally.
It needs to be performed in the following cases:
• When the vehicle collides and the airbag deploys, the corresponding fault code of
the collision data appears, the airbag indicator lights up, and the fault code cannot
be cleared.
3.19 TRANSPORT (Transport Mode)
This function can deactivate the transport mode, so that the vehicle can function normally.
It needs to be performed in the following cases:
• When the following functions are disabled, including limiting the vehicle speed, not
waking up the door opening network, and disabling the remote control key, etc. in
order to reduce the power consumption.
3.20 A/F (A/F Reset)
This function can set or learn Air/Fuel ratio parameters.
3.21 STOP/START (Stop/Start Reset)
This function can open or close the automatic start-stop function via setting the
hidden function in ECU (provided that the vehicle has a corresponding hidden function
supported by hardware).
3.22 NOX (NOx Sensor Reset)
This function can reset the catalytic converter learned value stored in the engine ECU.
It needs to be performed in the following cases:
• When the NOx fault is re-initialized and the NOx catalytic converter is replaced.
3.23 ADBLUE (Diesel Engine Exhaust Gas Filter)
After the diesel exhaust treatment fluid (car urea) is replaced or filled up, urea reset
operation is required.
3.24 SEATS (Seat Calibration)
This function can match the seats with memory function that are replaced and repaired.
3.25 COOLANT (Coolant Bleeding)
This function can activate the electronic water pump before venting the cooling system.
29