Snapper SPV2270HW Manual Para El Operador página 9

Figure 8: Removing the mulching plug
Assembly
Mounting the Grass Bag
1. To mount the grass bag on the mower, raise the rear
door (A, Figure 8). Removethe mulching plug.
Important: Themulching plug should be removed only when
bagging is desired, and should be replaced as soon as bag-
ging operations are completed.
.
Holding the grass bag by the handle (A, Figure 9),
mount the hooks (B) on either end of the grass bag
frame assembly onto the rear door pivot rod (C). Lower
the grass bag against the rear of the mower. Lower the
rear door.
Important: Make sure both grass bag hooks are mounted on
the pivot rod.
WARNING:Checkthe conditionof the grass
bag for wear or deterioration. If worn or
damaged, replace the parts onlywith
approvedfactory replacementparts.
Emptying the Grass Bag
WARNING:Beforeyou remove the grass bag,
stopthe engine. Beforeyou remove any grass
from the mower housing,disconnectthe wire
from the spark plug.
1. Raise the rear door to a vertical position.
2. Hold the handle of the grass bag and lift the frame
assembly. Continue to lift the frame assembly until the
hooks are no longer mounted on the pivot rod. Remove
the grass bag.
3. Empty the grass from the grass bag.
4. To mount the grass bag on the mower, see "Mounting
The Grass Bag".
Figure 9: Mounting the grass bag