Flex FX7211 Manual Del Operador página 16

REMOVE CABLE TIE AND STYROFOAM
BLOCK (FIG. 2)
(Used for shipping purpose only)
With the table surface on the ground, locate the
cable tie that anchors the motor/blade assembly
to the base. Using scissors or wire cutters, cut
and remove the cable tie.
Release the bevel lock handle, tilt the blade to
45 degrees, then remove the styrofoam block
located between the motor housing and the
table.
INTENDED USE
WARNING
This table saw is intended for rip, cross, miter,
bevel and non-through cut applications in
various wood and plastic materials.
Avoid overheating the saw
blade tips.
Fig. 2
If cutting plastic, make sure the feed rate is slow
enough and blade tips are sharp enough to
avoid melting the plastic.
Do not use this table saw for cutting metals,
such as aluminum or copper, or any masonry or
cement materials.
-16-
Remove Styrofoam
Block
Remove
Cable
Tie