WIKA CPG1000 Manual De Instrucciones página 19

5. Transport, packaging and storage
5. Transport, packaging and storage
5.1 Transport
Check the precision digital pressure gauge for any damage that may have been caused by
transport. Obvious damage must be reported immediately.
5.2 Packaging
Do not remove packaging until just before mounting.
Keep the packaging as it will provide optimum protection during transport (e.g. change in
installation site, sending for repair).
5.3 Storage
Permissible conditions at the place of storage:
Storage temperature: -20 ... +70 °C
■
Humidity: 0 ... 90 % relative humidity (no condensation)
■
Avoid exposure to the following factors:
Direct sunlight or proximity to hot objects
■
Mechanical vibration, mechanical shock (putting it down hard)
■
Soot, vapour, dust and corrosive gases
■
Potentially explosive environments, flammable atmospheres
■
Store the CPG1000 in its original packaging in a location that fulfils the conditions listed
above. If the original packaging is not available, pack and store the CPG1000 as described
below:
1. Wrap the CPG1000 in an antistatic plastic film.
2. Place the CPG1000, along with shock-absorbent material, in the packaging.
3. If stored for a prolonged period of time (more than 30 days), place a bag, containing a
desiccant, inside the packaging.
WARNING!
Before storing the precision digital pressure gauge (following operation),
remove any residual media. This is of particular importance if the medium
is hazardous to health, e.g. caustic, toxic, carcinogenic, radioactive, etc.
WIKA Operating Instructions Model CPG1000
GB
19