Publicidad
Idiomas disponibles
Idiomas disponibles
Installation using
ISOFIX System
and 3-point belt
or using 3-point
belt only
5
17
See images
-
5
Fit the ISOFIX guides with the
ISOFIX anchor points. The ISOFIX
guides can protect the surface of
the vehicle seat from being torn.
They can also guide the ISOFIX
connectors.
6
Press the ISOFIX adjusting
button to pull out the ISOFIX
connectors.
Rotate the ISOFIX connectors
7
180 degrees until they are
pointing in the direction of the
ISOFIX guides.
8
Line up the ISOFIX connectors
with the ISOFIX anchor points,
and then click both ISOFIX
connectors into the ISOFIX
anchor points.
! Make sure that both ISOFIX
connectors are securely attached
to their ISOFIX anchor points.
The colors of the indicators on
the both ISOFIX connectors
should be completely green.
! Check to make sure the booster
is securely installed by pulling on
the both ISOFIX connectors.
Press the ISOFIX adjustment
9
button to retract the seat back
to desired position.
To remove the booster:
10
Press the secondary lock button
first and then the button on
the ISOFIX connectors before
removing the booster from the
vehicle seat.
11
Rotate the ISOFIX connectors
by 180 degrees, then press the
ISOFIX adjusting button to fold
the ISOFIX connectors.
Insert the end of shoulder belt
positioning clip webbing into the
hole on the base.
12
! Please check the direction of
shoulder harness anchor as
to avoid hurting the child's back
if shoulder harness anchor is in
the opposite direction.
! Pull the shoulder belt
positioning clip webbing slightly
to make sure the webbing fixed
on the base.
13
! Slide shoulder harness anchor to
adjust webbing length.
Slide the shoulder belt positioning
clip to make sure the clip is close to
16
child's shoulder,
-1 buckle the
16
-3
vehicle safety belt.
9
! To achieve the safest installation,
we suggest the shoulder belt
positioning clip should be level
with the highest point of the
child's shoulder.
! DO NOT position vehicle belt
over top of the armrests. It must
pass underneath the armrests.
16
-2
! The booster can not be used if
the vehicle safety belt buckle
(female buckle end) is too long
to anchor the booster securely.
16
-4
! After your child is placed in this
booster, the safety belt must
be used correctly, and ensure
that any lap strap is worn low
17
down, so that the pelvis is firmly
engaged.
16
! Place a booster firmly against
the back of a forward-facing
vehicle seat equipped with a
lap/shoulder belt.
Use Cupholders
See images
18
Detach Soft Goods
See images
19
Care and
Maintenance
Please wash the seat cover and inner
padding with cold water under 30°C.
Do not iron the soft goods.
Do not bleach or dry clean the soft
goods.
Do not use undiluted detergents,
gasoline or other organic solvent to
wash the child restraint. It may cause
damage to the child restraint.
Do not wring out the seat cover and
inner padding to dry. It may leave the
seat cover and inner padding with
wrinkles.
Please hang dry the seat cover and
inner padding in the shade.
Please remove the child restraint
from the vehicle seat if not in use for
a long period of time. Put the child
restraint in a cool, dry place where
your child cannot access it.
gracobaby.eu
www.gracobaby.pl
10
Publicidad
