Publicidad
Idiomas disponibles
Idiomas disponibles
Using the SmartDispense'"pedestal.
To Fill Your Fabric Softener Tank:
1. Open the tank for filling by turning the cap
counterclockwise until the cap is loose. Lift
the cap off.
.
.
NOTE:Do not fill the tank while it is
removed from the drawer. Fluid mag
be lost while reattaching the tank
to the SmartDispense sgstem.
Aim the fabric softener bottle at the
opening in the tank and begin to fill.
The fabric softener tank will hold 95 oz.
of concentrated liquid fabric softener.
The sgstem requiresthat at least
30 ounces of new fabric softener
must be added to the tank to
recognize that it has been filled.
When full, replace the cap and turn
clockwise until tight to ensure proper
sealing. If residue is left on the tank, wipe
clean with a moist cloth, using a mild soap.
°
An indicator will appear on the washer
control panel to notifg gou when the
dispenser needs to be filled again. After
filling the tank, the warning message
will turn off when the washer is powered
on for the next cgcle.A full tank using
concentrated liquid fabric softener
will last approximatelg 3 months
for the average user.
NOTE: The fabric softener sensor should be
wiped cleon every time the tank needs to be
refilled. To remove the fabric softener sensor
while the drawer is fulkj opened, grasp the
sensor at the rear of the tank, using the grip
provided, and pul! the sensor straight up.
Wipe the surface of the sensor, using a moist
cloth with a mild soap; then replace the
sensor back in its original position.
10
Publicidad
